Mortex® Rapid +
Mortex® Rapid+ is a product designed to fill holes and cracks or splits through which water under pressure is present (even for repair of terracotta piping).
Application and characteristics
Mortex® Rapid+ is an ultra-rapid setting grey-coloured mortar (20 to 30 seconds after warming) to stop water under pressure. This product can also be used as an anchoring mortar. Setting can be delayed by adding fine sand up to 50% or accelerated by mixing with hot water.
We advise that you always carry out a preliminary test to determine the quantity of powder and setting time according to the ambient temperature and the humidity of the air.
Packaging
- Available in 20 kg bag
- Available in 5 kg bucket
Our recommendations and our specifications are given in good faith and based on current research, they do not constitute a guarantee.
We cannot be held responsible for damage that might be caused by incorrect use of the product.
We guarantee a consistent quality in the supply of our products, however, we cannot be held liable in the event of lack of success or unexpected end result as the conditions of use remain outside our control.
In case of doubt, please consult our technical service.
We cannot be held responsible for damage that might be caused by incorrect use of the product.
We guarantee a consistent quality in the supply of our products, however, we cannot be held liable in the event of lack of success or unexpected end result as the conditions of use remain outside our control.
In case of doubt, please consult our technical service.
